Guidelines for Upgrade the Hardware in an Inspiron 6400

tags

Upgrading the hardware inside your Dell Inspiron 6400 laptop can tremendously enhance your computer’s common performance. standard hardware upgrades consist of the hard drive, RAM module and film card devices. Some hardware like RAM needs minimal disassembly, although you may possibly maybe have to totally disassemble your laptop to receive entry for your film card. In both case, the typical laptop operator can replace hardware from the Inspiron 6400(Dell inspiron 6400 battery) with minimal specialized understanding.

Issues You will Want:Phillips thoughts screwdriver and Upgrade difficult Drive
1
Turn off your laptop, disconnect the power cable, and eliminate the battery pack from its compartment.

two
Place the laptop facedown, and then eliminate the two retaining Phillips thoughts screws attaching the challenging drive compartment towards the bottom casing assembly.

3
Slide the difficult drive away from its compartment and arranged it apart to assure that it is out of the way.

four
Slide the new difficult drive into the compartment till the best of the hard drive casing is flush using the external laptop casing. Replace the two Phillips mind screwdrivers.

Upgrade Wireless Card
1
Location the laptop faceup, and then available the lcd until it is fully extended. Use a tiny flat-head screwdriver to pry up the hinge/keyboard cover located in amongst the keyboard and also the LCD.

2
Eliminate the Phillips mind screws securing the keyboard towards the upper casing assembly. Lift the keyboard(such as Dell laptop keyboard) out of the upper casing, and then location it facedown much more than the palm rest. Disconnect the ribbon cable tv from the motherboard and arranged the keyboard aside.

3
Remove the two Phillips thoughts screws on the bottom edge of the show. close the lcd and spot the laptop vertically so the hinge is faceup. remove the two Phillips thoughts screws from the rear edge of the laptop. place the laptop faceup, and then obtainable the lcd panel and remove the two Phillips thoughts screws close to the display hinges. Disconnect the antenna cables, get rid of the grounding screw, and disconnect the film cable television from the motherboard. Lift the lcd off the upper casing assembly and quite meticulously arranged it towards the side.

four
Get rid of the two retaining Phillips mind screws securing the movie card and heat sink assembly towards the motherboard. Lift the movie card and heat sink assembly out of the laptop and arranged them towards the side.

five
Repeat measures a single by way of four in reverse obtain to set up the new film card.

Upgrade RAM
1
Place the laptop facedown, and then remove the two Phillips thoughts screws attaching the RAM compartment cover towards the bottom casing assembly. Lift the cover off the casing and arranged it towards the side.

two
Push about the latches on both aspect of the RAM module, and then tilt the module at a 45-degree angle. Lift the RAM module out of the memory compartment and spot it inside a little, static-free plastic material bag.

three
Slide the new RAM module into the compartment till the two latches snap the RAM module into location.

four
Repeat this process for each and every and every single RAM module you eliminate and set up.