Wall Frames – How to Install Wall Image Frame Hardware


Right here are some suggestions on attaching image frame hardware to your wall frames.

There are truly two major actions to installing wall frame hardware. Initial, you have to decide on the right wall frame hardware for the frame you want to hang. Second, you have to put the hardware in the correct place on the picture frame. Despite the fact that this may seem super basic, it can be difficult. So, here are some suggestions to installing picture frame hardware on your wall frame.

Step #1: Use the Correct Picture Frame Hardware

If it is a very good prepared-made picture frame not larger than 11×14 inches, then it usually comes with the image frame hardware. If it does not come with hardware, then a saw-tooth hanger or two eye hooks will solve the difficulty. These products can be found at your neighborhood hardware retailer.

You ought to use a saw-tooth hanger if your wall frame is smaller than 11×14 inches as these are fairly effortless to set up. Saw-tooth hangers come in various sizes, so if your wall frame is smaller sized than 8×10, small or medium-sized saw-tooth hangers would work nicely. Bigger frames like 11×14 or 8×10 call for larger saw-tooth hangers. For heavy frames or large image frames, it is very best to use eye hooks as they can handle the added weight or size much better than saw-tooth hangers. Eye hooks are a little far more difficult to set up because they require more effort and a couple of further steps.

Step #2: Identify How You Want to Hang the Frame

Recognize the path you’d like to hang the wall frame, and start installing the suitable image frame hardware.

For saw-tooth hangers, make positive it is attached straight and center (or you will have a challenging time hanging the wall frame appropriately). Measure the width of the frame, then divide the measurement in two to spot the saw-tooth hanger dead-center. A small level can aid you double verify if the hanger is on straight or not.

Eye hooks, on the other hand, are screwed into the frame’s wood molding to greater manage the weight of the frame. To install eye hooks, you have to screw the two hooks in and string a wire via them. Prior to screwing the eye hooks in, make a decision where to spot them. Place pencil marks exactly where the screws go before you commence. The hooks are meant to be screwed into the frame’s appropriate and left sides. Measure 1/3 of the way down the sides of the frame from the best and mark them — these are the spots exactly where the eye hooks go in. Pre-drill holes when you get the spots correct and then screw in the eye hooks. With the eye hooks in location, thread the wire through them. Make positive that the hooks are even and use just the proper length of wire to make your wall frame lay perfectly on the wall. Make confident to leave some slack in the wire — if you thread it also tightly, the frame will not show properly on the wall.

Installing the image frame hardware on these wall frames may possibly seem a bit difficult at very first, but if you are good with your hands, it really is fairly straightforward. If you happen to be not so certain, ask your frame retailer to do the job for you the initial time. Afterwards, you can attempt it oneself the subsequent time about.